Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge R6415 Installation and Service Manual

PDF

Removing a hot swappable power supply unit

Prerequisites

  • CAUTION: The system needs one power supply unit (PSU) for normal operation. On power-redundant systems, remove and replace only one PSU at a time in a system that is powered on.
  1. Follow the safety guidelines listed in Safety instructions.
  2. Disconnect the power cable from the power source and from the PSU you intend to remove, and then remove the cable from the strap on the PSU handle.
  3. Unlatch and lift the optional cable management arm if it interferes with the PSU removal.

    For information about the cable management arm, see the system’s rack documentation at Dell.com/poweredgemanuals.

Steps

Press the orange release latch and pull the PSU out of the system using the PSU handle.
Figure 1. Removing a power supply unit Removing a power supply unit

Next steps

Install a PSU, for more information, see Installing a hot swappable power supply unit or install a PSU blank, for more information, see PSU blank.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\